[Kawasexy]

My upper radiator hose on the clutch side decided to magically started a small leak and it was a fuzz loose. Any one have torque specs on it so I'm not over doing it. Thanks. Gen4

Sent from my XT1565 using Tapatalk

 

[belkins]

Torque - Water Hose Clamp Screws: 3.0 N·m (0.31 kgf·m,27 in·lb)

 

[Kawasexy]

Torque - Water Hose Clamp Screws: 3.0 N·m (0.31 kgf·m,27 in·lb)

Thank you so much sir!

Sent from my XT1565 using Tapatalk

 

[scout]

keep eye on that hose or area.

 

[Kawasexy]

keep eye on that hose or area.

Definately will do. The clamp was loose not sloppy but it was easily turned with minimal effort.

Sent from my XT1565 using Tapatalk

 

[scout]

Definately will do. The clamp was loose not sloppy but it was easily turned with minimal effort.

Sent from my XT1565 using Tapatalk

The loose bolt is probably the problem but, fyi, I had either r1 or fz1 that did the coolant two drop thing and if was a failed water pump gasket.

I mention the above not because I think it's your problem, but only to share my past history;

on that one, YUCK (yamaha) warranty covered.

 

[The Prophet]

Tight enough to not leak. That's how tight I make um.