CAn I get a few maps please. | Kawasaki ZX-10R Forum

1 - 1 of 1 Posts

busaforhire

·

Registered

Joined Jul 5, 2005

·

1,945 Posts

Discussion Starter • #1 • Jul 23, 2005 (Edited)

I installed the pc3 and tried the Dan Kyle Sato slip-on map and it ran like dog poo.. felt sluggish and slow to respond I put in the stock dynojet map and it ran much better(good actually) but I know there is more to be had.
Can anyone please email me a map if you think it'll come close to fitting my application..
mods are BMC race filter, Pc3, and Sato slip-on exhaust. no TRE.
TIA

email them to [email protected] :thumbsup: thanks
please let me know what your combo is as well.

1 - 1 of 1 Posts

Join the discussion

Recommended Reading

Gen 5: 2016- Zx10rr kqs

Performance and Tech

I have annoying problem with the KQS. Going up 3rd is near impossible to get other than the first two laps. It was the same with the stock pegs, is the same with rearsets. The bike had the recall for the suspect gear and I feel the KQS to 3rd got worse after that, although it did more track work...
- 3
- 378
- G
  GreenMeanieOz · updated 2 days ago
Gen 1: 2004-2005 Simple engine build

Performance and Tech

I'm starting to build up a new motor for my G1 track bike. I have gathered a clean core motor (28k, almost all highway commuter miles, great compression), G1 kit intake cam, and a few other items. I tore the motor down yesterday to send the head out for a clean/beadblast/mill/port/rebuild and...
- 39
- 3K
- EvokedPotential · updated 2 days ago
Clutch Issues

Performance and Tech

Tech question. Bike stalled on me the other day when I was rolling up to a stop sign with the clutch pulled in. Now when I try starting the bike in first with the clutch pulled in the bike moves forward. Like the clutch isn’t disengaging. I have proper 3mm clutch lever free play. Took the cover...
- 4
- 116
- KEValenta · updated 2 days ago
Over Fueling

Performance and Tech

Hi There, I’m in NewZealand and race an Open Wheel Lightning Sprint, have just installed a 2008 zx10r. Had an ECU flash done then onto dyno for tuning, for some reason a sensor is telling it that it needs more fuel than necessary, fuel pressure set at 43psi but far too rich, went as low as 28psi...
- 1
- 94
- P
  Pops · updated 4 days ago
Gen 4 throttle bodies on Gen 5 engine - gear sensor

Performance and Tech

If a gen 4 throttle body, wire harness and ECU are installed on a gen 5 engine, will a gen 4 gear position sensor work properly on the gen 5 engine? I've read that a gen 4 gearbox can be installed in a gen 5 engine and then the gen 4 gear position sensor will work. I'm wondering if the gen 4...
- 2
- 183
- M
  mcescher · updated 5 days ago

Join now to ask and comment!

Top