Kawasaki ZX-10R Forum banner

1 - 3 of 3 Posts

2,897 Posts
Discussion Starter #1
I am wiring an LED Brake/Turn bar.

The wiring schematic for the bar is this:
Ground - black
Red - Brake
Blue - Left Turn
Yellow - Right Turn

Factory Wiring Schematic:
BK/Y and Gray - Left Turn
BK/Y and Green - Right Turn
BK/Y and Red - Brake

Should I join all the BK/Y wires together for the ground wire on the LED bar? Based on the Kawi electrical schematic BK/Y is just a common ground(?)

Servo's Eliminatus ;)
6,813 Posts
I know this is an old thread, but I am looking at a light bar for mine.

Did yours look like this one, and if so, where did you get it?


1 - 3 of 3 Posts