Kawasaki ZX-10R Forum banner
1 - 1 of 1 Posts

· Registered
11 Posts
Discussion Starter · #1 ·
Hi guys, I have removed the ABS lines out of my new bike. Left the ABS pump in there and just blocked off the pump with 4 screws. Was expecting to get ABS error code, but disaster has happened. Following error codes:
I do have the service manual,so I do know what codes are. But I have not done anything else to the bike or nor unplugged anything else. Bike still has standard ECU and harness with Woolich in it.
Bike has gone into limp mode with dash flashing and not revving over 12kRPM. I must mention this is a race bike
Any help appreciated
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.