Kawasaki ZX-10R Forum banner

1 - 6 of 6 Posts

·
Registered
Joined
·
15 Posts
Discussion Starter #1
I purchased a set of block off plates for my 04 zx10. When dissembling the old stuff I notice that there is a plug attached were the two hoses come together. Do I just leave this unplugged. Will it trip any engine lights?

look at #1 in the picture and you will see were the plug was.
 

Attachments

·
Registered
Joined
·
1,688 Posts
I assume you are refering to the 2 wire electrical plug?

On the newer generation ZX10's you have to either leave it plugged in, or use a jumper wire.

There are a couple of "How To's" on here with pics.
 

·
Registered
Joined
·
15 Posts
Discussion Starter #3
Can anyone provide me a link to the pervious thread. I have searched through 20 pages and could not find what I was looking for.
 

·
Banned
Joined
·
1,056 Posts
You can leave the wires to the electrical solenoid "unplugged" with NO issues on 1st and 2nd gens, its the 3rd Gen that needs jumpered. So you should be OK. :thumbsup:
 
1 - 6 of 6 Posts
Top