Kawasaki ZX-10R Forum banner

1 - 18 of 18 Posts

·
Registered
Joined
·
194 Posts
Discussion Starter #1 (Edited)
FOR SALE: 2013 RACE Bike Built by Jeremy Toye ($12.5k)

PRICE REDUCTION
Updated with links to some of the parts so you can check them out.

WHOLE PACKAGE $10,800 = FULLY BUILT RACE BIKE + STREET + SPARES
Selling off spares


2013 ZX10R Race Bike built by Jeremy Toye of Lee's Cycle
Makes ~190 hp & 85 ftlb

Special Goodies
- Kit harness
- Kit ECU
- Custom mapping by Jeremy Toye of Lee's Cycle (for U4 & pump gas)
- Also has a pit speed limiter as part of the mapping
- Sick traction control program installed
- JRi shock with one extra spring - Sport & Road Racing | JRi Shocks
- GP cartridges with extra springs - KFG Racing Your Full Service Performance Factory! Motorcycle race and street service in Auburn, Washington, Seattle, Tacoma, Kent, Bellevue, Covington
- Rear link (made by Jeremy)
- Ohlins steering damper
- Graves progressive throttle tube (quick turn, only better)
Graves Motorsports R1 R6 Progressive Throttle Tube
- HM quick shifter (hella expensive Euro part bcuz the Kawi gearbox is too clunky for the normal Power commander/Bazzaz/etc QS to work reliably; per Jeremy when I asked why I needed a $300 quick shifter. It works hella good though :ayyy:
HM Quickshifter ? Product Categories ? HM Quickshifters
- Super trick swing arm mods - I'll give details to serious buyers - but this mod that Jeremy did is what makes this ZX10 standout. Jeremy spent years developing the ZX (you can find his articles in RRW detailing the experiments). This mod helps the chassis handle profoundly better than a stock swing arm.

Race Basics
- Sharkskinz body work with prof paint job
- Extra upper and tail section
- Extra windscreen
- Enforced case covers
- Graves clip ons - Graves Motorsports 50mm Clip-on Motorcycle Handlebars
- Full Graves Ti exhaust - Street Bike Parts`Sportbike Exhausts`Yamaha R1`R6 Parts`Suzuki GSXR Parts`Honda CBR Parts`Motorcycle Race Parts`Yamaha Racing` Dynojet Power Commander`
- Vortex rear sets
- 520 chain with Vortex sprockets
- Steel braided brake lines in front (not rear)
- Fancy, expensive brake pads that are hella good (but I can't recall the brand right now lol)

I still have ALL the street equipment - literally EVERYTHING except the stock steering damper. From the license plate mudflap to the exhaust to the stock wiring harness.

No longer street registered; currently on PNO (Planned Non-OP)

History
- Purchased new Oct 2012
- Has a little over 2k miles on it
- Been down twice - minimal damage (cosmetic).
- All four rims are straight and undamaged.
- Measured by Lenny Albin - frame is straight and good condition.
- Well maintained - oil changes every race weekend.
- Calipers cleaned every few weekends.
- New clutch installed in January 2015
- Lots of notes in my notebook that details maintenance history, modifications and set up details for various tracks.


I'll upload pics as requested.

Meanwhile - check out this thread for lots of photos & stories of racing adventure. :popcorn2:
http://www.zx-10r.net/forum/f78/adventures-racer-girl-230794.html


Asking $12.5k for ALL of it.
Delivery within SoCal can be arranged; anything else will be discussed.
Located in the Carson/Torrance area (just west of Long Beach)

Send me a PM for questions/inquiries. If it goes further; I'll give you my number for further discussion.
Or email - kkubran at gmail

If you're interested; I can share all my notes on this bike - set up, etc.

Sorry guys, no parting out until the whole package has been listed for a while. If it doesn't sell after a while, then I'll part it out.

By selling the whole package; you, the lucky buyer, could sell off all the spares & street stuff you want to recoup at a minimum $1-$2k! The wheels and street equipment alone is worth a couple grand. The street body work was used when I broke in the engine on the race track. It is literally in perfect condition. I removed several pieces prior to breaking in the engine; and many have only the 1 mile from the dealer ride.
I taped up leading edges to prevent any chips from following others around the track.

You can buy a FULLY PREPPED race bike; built by a guy who's done development work for the last 4 years on a ZX-10R, has won numerous races on it; for a little less than the price of a brand new street bike AND you have approx $2k worth of items you could sell off.

A few details about the man who built this bike:
Jeremy Toye Wins Pikes Peak by being the only bike under 10 min; and wins the Rookie award since it was his first time doing the race.
http://www.roadracingworld.com/news/pirelli-celebrates-its-successful-2014-road-racing-season-in-north-america/

http://www.roadracingworld.com/news/video-jeremy-toyes-winning-run-at-the-pikes-peak-international-hill-climb/

http://www.roadracingworld.com/news/toye-wins-top-motorcycle-honors-at-pikes-peak-international-hill-climb/
 

·
Registered
Joined
·
194 Posts
Discussion Starter #2
Pic from Vegas race. 2014
 

Attachments

·
Registered
Joined
·
194 Posts
Discussion Starter #3
Fontana, Jan 2015
 

Attachments

·
Registered
Joined
·
194 Posts
Discussion Starter #4
A gorgeous shot from March 2014 - first race weekend on the bike - by Joe Salas of 4theRiders
 

Attachments

·
Registered
Joined
·
194 Posts
Discussion Starter #5
Unfortunately, I didn't take a whole lot of photos while the bike was in street trim... here are some pics from when I took it to Chuckwalla for engine break in.

I picked it up at the dealership, and headed straight out to the track. I followed break in rules per the Kawi recommendations, and per Jeremy Toye.

Photos below
 

·
Registered
Joined
·
194 Posts
Discussion Starter #6
Pics from First Ride CVR Oct 2013

Loaded it at the dealer and headed straight out to Chuckwalla Valley Raceway for engine break in.

I stripped off as much body work as possible to keep it from getting chipped. I layered masking tape (not shown) on the leading edges to prevent chips.

These photos were taken during various phases of work; such as removing the mirrors; and swapping the crap stock tires for old race take offs.
 

Attachments

·
Registered
Joined
·
194 Posts
Discussion Starter #7
Selling spares separately

Ok guys, I'm going to sell off the spare parts individually ...

See the above list for the spares
 

·
Registered
Joined
·
1,902 Posts
How much for the upper and lower? And set of wheels with Rotors?
 

·
Registered
Joined
·
194 Posts
Discussion Starter #9
How much for the upper and lower? And set of wheels with Rotors?
Which upper & lower? Street or race?

The wheels are fully intact; ready to put on & roll.

For a little extra I'll leave the Pirelli superbike slicks on them. Soft (SC1) rear & medium (SC2) front. Both have just a few races on them.

Send me an email kkubran at gmail & I'll respond with a price & photos.
I have 2 uppers, the one on the bike is in good condition, the other has some minor damage. If you'd like both, I'll throw in the damaged one at a discount.

If you'd only like one upper, I'll give you a price for the good one & the damaged one. Please send an email with answers to the questions & your name & any additional contact info you'd like to share.

Btw, there's only one lower. It's used but not damaged save for the usual wear & tear of the race track.

Thanks!
Krystyna
 

·
Registered
Joined
·
194 Posts
Discussion Starter #10 (Edited)
Wheels are SOLD but the slicks are available if anyone is interested in some take offs

$150 shipped



Front: SC2 (medium)
Rear: SC1 (soft)
Have less than 20 laps on them.
Rear has some minor tearing that came from the track having been resurfaced. It will not affect tire performance; and will be gone after a few good laps on a track with a good surface (ie-not new).
 

·
Registered
Joined
·
194 Posts
Discussion Starter #13
Just a quick note; I was in a gnarly moto street crash on Friday (26th) & I've been told my head was wedged up between the truck's rear axle & the bed.

My apologies for any late responses.

Thnx!!
Krystyna
 

·
Chairman of the Board
Joined
·
16,056 Posts
Just a quick note; I was in a gnarly moto street crash on Friday (26th) & I've been told my head was wedged up between the truck's rear axle & the bed.

My apologies for any late responses.

Thnx!!
Krystyna
No apologies needed. Are you okay? That's the important thing.
 

·
Registered
Joined
·
1,442 Posts
Just a quick note; I was in a gnarly moto street crash on Friday (26th) & I've been told my head was wedged up between the truck's rear axle & the bed.

My apologies for any late responses.

Thnx!!
Krystyna
Oh no! Hope you're good!
 

·
Registered
Joined
·
194 Posts
Discussion Starter #18
bike is sold
 
1 - 18 of 18 Posts
Top