Kawasaki ZX-10R Forum banner

1 - 9 of 9 Posts

·
Registered
Joined
·
4,818 Posts
6204 (you need 2) for the REAR wheel. This is a 20mm axle hole.

6205 (you need 1) for the cush drive if you plan on replacing the cush drive bearing as well.
What the heck did I find then? :dontknow: :badteeth:
 

·
Newfie Bullet
Joined
·
2,341 Posts
Seeing yer doin bearings..do a lil research on doin ceramic bearings(full set is about $300 i think)..
I never tried it or know anything about them other than race teams use them everywhere..Cars,trucks,bikes,alts,water pumps..worth the look and see time i say..
Seems it frees up some drag on the car/bike/ect.....Someone here did a 60 to 0 roll test on their gen 3 i think,made a big diff..
 
1 - 9 of 9 Posts
Top