Kawasaki ZX-10R Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
53 Posts
Discussion Starter #1
was wondering i looked at a pair of no cuts and they seem like only left side needs to be cut and does anyone have specs on torque ratingn for those didnt install yet but would like to just waiting to see if anyone had some info 1st thanks maybe a close up pic of both sides for a little extra help
 

·
Registered
Joined
·
211 Posts
Only have left side picture for you, right side is very easy as it goes right to the frame.

DSC07721zzz.jpg

Service manual should have the torque specs.
Be careful and take your time or you might scratch it up like I did, used some trim to cover up the rough edge.

You might also want to read up on how others did their cut if you have never done it before.
 

·
Dont mess wit White Ninja
Joined
·
5,932 Posts
Save your money, in the long run a frame slider will do more damage than good. There great for low speed stuff, but dump that sucker at about 80mph & say good bye to your frame or engine mounts! Don't ask me though, I've only learned twice:rolleyes::headshake:badteeth::lol:
 
1 - 4 of 4 Posts
Top