Kawasaki ZX-10R Forum banner

swingarm

  1. Gen 1: 2004-2005 Ride Height after Swingarm Swap

    The ZX-10R
    Hi everyone, I have recently purchased a Gen 3 swingarm to swap onto my Gen 1, since the original has a dent in it. I have been reading about the swap, and people have reccomended I use 05/06 linkages. Does this put the bike at the stock ride height? How will this affect the handling? I would...
  2. Gen 2: 2006-2007 Mcintosh Alumi-pro install

    Performance and Tech
    I'm getting ready to install a Mcintosh Alumi-pro swingarm on my bike and was wondering if anyone has any tips or tricks to the process. If anyone has any information on the brake arm I could use the help. I feel a little shady in this area. Thanks for any info in advance!
  3. Gen 1: 2004-2005 FS Extended Swingarm

    Parts, Gear and Accessories
    Hello I'm selling this arm because its just sitting in my garage, and it needs a good home. It is a stock Gen 1 swingarm with welded in extentions. This arm can fit on Gen 2 & 3 also... The extentions are not bolt ins that were welded in, these were CNC machined and welded in. The swingarm was...
  4. 08 ZX10R Swingarm

    The ZX-10R
    Hey guys, searched around a bit for this one but didn't find much. I'm trying to take the swingarm off my 08 10R and have gotten as far as removing the rear wheel, shock, mud guards and chain from the drive sprocket and then removed the swingarm pivot shaft nut and pulled out the shaft but the...
Top