Kawasaki ZX-10R Forum banner

pc5

  1. Gen 4: 2011-2015 Warning Lights after PC5 install

    The ZX-10R
    So here's the jist. I installed my Taylormade exhaust and PC5 last night. When I started her up the FI Light was on, red warning light, yellow flashing warning light, traction control lights 1-3 blinking, and gear showed 6 no matter what gear I was in. However, she ran like a raped ape. I...
  2. too much backfire on pc5 help!!!

    General Motorcycle Discussions
    So i have a 2010 zx10r. i just hooked up my power commander 5 installed my k&N race filter and have Mgp growler slip on i am currently running the map off the pc website. But when i was out riding it felt really sick in the lower rpms but when i got to the top and let off the gas i was getting a...
  3. Gen 4: 2011-2015 Flash, PC5, Autotune, custom mapping, etc

    The ZX-10R
    I need help understanding something about the gen 4 with all the different mapping and everything I have heard people say they are doing. the ecu flash removes the restrictions set on the bike (I understand that part). But with that if I had a PC5 that would allow a custom map. but the...
  4. PCV - Who can help with this phenomenon?

    The ZX-10R
    Hi! After installing PVC & Autotune on my ZX10r 08 (european) and some acceptations of the autotune trims the bike goes better than before. BUT: Gear 1...4 are ok. Only with gear 5 & 6 and only in the low rev / low thottle area the bike starts to bog and shows hard load changes. it seems...
  5. How-To: Clean Install of a PC5 (PCV) on your 2008-2009 ZX-10

    The ZX-10R
    Alright I can't find them online, but the instructions provided for the PCV by Dynojet are pretty good, but the suggested mounting location sucks. They recommend you set the power commander in the trunk (under passenger seat) basically just sitting there, with the wires coming out of it facing...
Top