Kawasaki ZX-10R Forum banner

gen1

  1. [Gen1] Can you fit a 200/60 on rear wheel?

    Suspension and Tire Tech
    can you fit a 200/60 on gen 1 rear wheel? I'm gonna be running my street bike at the track 2 weeks from now due to blowing up my trackbike's transmission and I will probably swap out my S21's for a set of slicks i have laying around and was wondering if a 200 rear fits a Gen1 Rear wheel.
  2. Gen 1 Gearing

    Performance and Tech
    Wanting to know what a good gearing setup for highway riding, wanting lower rpms since I already have a loud exhuast. Current setup is 17, 40
  3. Green X2 Gallery

    The ZX-10R
    My Gen1 with 20k and Gen3 with 1k
  4. Gen 1: 2004-2005 hossack frame design

    The ZX-10R
    Hey guys, I.m working on designing a hossack suspension frame for 1st gen zx10 does any one know where i can get detailed measurements for the frame and engine this is going to be a composite frame aluminum rear engine mount and swing arm pivot, chrome moly or titanium trellis to front...
  5. Gen 1: 2004-2005 FS Extended Swingarm

    Parts, Gear and Accessories
    Hello I'm selling this arm because its just sitting in my garage, and it needs a good home. It is a stock Gen 1 swingarm with welded in extentions. This arm can fit on Gen 2 & 3 also... The extentions are not bolt ins that were welded in, these were CNC machined and welded in. The swingarm was...
  6. Gen 1: 2004-2005 ECU vs key?

    Performance and Tech
    Recently bought an ECU off of eBay and had it mapped by Dynotronics for an '05 (following a bunch of mods, race exhaust, stacks air fliter...). The original one still works in the bike, but the remapped one does not. The fuel pump doesn't activate as it usually does when the key is turned on. Is...
Top