Kawasaki ZX-10R Forum banner
autotune
1-6 of 6 Results
  1. The ZX-10R
    Have a few ?. On woolich auto tune what the best afr. And instead of block off plates . I jest removed the valve and connected a hose from nipple to nipple. Or should I use block off plates. And what would be the next best mod I have no cat m4 slip on should I change the sprockets. Thanks any...
  2. The ZX-10R
    I need help understanding something about the gen 4 with all the different mapping and everything I have heard people say they are doing. the ecu flash removes the restrictions set on the bike (I understand that part). But with that if I had a PC5 that would allow a custom map. but the...
  3. Riders Discount
    Designed to compliment any bike with a Power Commander V already installed, the Autotune Wideband O2 Controller from Dynojet uses the same software employed on Dynojet’s dynamometers that trained professionals use to build custom maps. No more trips to the dyno required, just install the...
  4. The ZX-10R
    Hi! After installing PVC & Autotune on my ZX10r 08 (european) and some acceptations of the autotune trims the bike goes better than before. BUT: Gear 1...4 are ok. Only with gear 5 & 6 and only in the low rev / low thottle area the bike starts to bog and shows hard load changes. it seems...
  5. Performance and Tech
    Kleen Air system! Autotune... Hi from germany, i've bought the pc5 and the autotune thing. in some of the posts here is written that to use the autotune the "clean air system" must be off / blocked, otherwise the autotune will be damaged. What is the clean air system and how can i block...
  6. Performance and Tech
    Hi from germany, i´ve the european modell zx-10r 08 with 2 stock o2 sensors, thread size 12mm. The new Auto Tune from dynojet comes with an o2 wideband sensor, thread size 18mm = problem. where do you have installed your o2 sensor for auto tune??? Maybe the best way should be to remove one...
1-6 of 6 Results
Top