Welcome to ZX-10R.net
General Discussions
ZX Network
Marketplace / Classifieds
Vendor Member Section
Want to Grow Your Business? Learn more about becoming a Supporting or Premium Vendor
GPS
Latest Posts
-
The ZX-10RHey guys, I am in search of a Gen 4 engine, my friends bike spat its rods through the case (16000km). This is the second time someone I know has had their Gen 4 engine blow up on them. Is this a common issue with ZX10s compared to other litre bikes? I have not heard of any other Japanese 1000s...
- 16
- 296
-
Performance and TechHi all, picked up a 2015 10r a few months ago with a vance and hines cs one urban brawler slip on installed to the pre muffler. I have searched high and low to see if there is a link pipe that will take the place of the pre muffler to no avail. This is temporary as I would like a full SC in the...
- 6
- 54
-
The ZX-10RHey everyone new member I was replacing the valve cover gaskets and spark plug gaskets on a gen 1 and took off the breather caps and saw the reeds we're dirty can they be cleaned or replaced and if so does it make a difference ? Any advice would be welcome picture added to post.
- 0
- 30
-
Welcome Newbies!OK. I'd like to address some issues that I think keep commin up. This is MHO, so dont freek out if you find it offensive. FIRST: Why does my 10r bog down below 5K? Well for one we have what we call a close ratio tranny. To help keep you from wheelieing EVERYWHERE in first due to the min of...
- 383
- 93K
-
Wanted: Buy or TradeHi All, I'm probably barking for even asking this here :) I'm on the look out for a complete fairing set for my '05 ZX-10R The bike is currently finished in RAW Titainium but most of the panels are rough to the point where lots of plastic tabs etc... have snapped off so I'd rather replace...
- 4
- 173