Kawasaki ZX-10R.net - Reply to Topic
Thread: Regulator mounting Reply to Thread
Send Trackbacks to (Separate multiple URLs with spaces) :
Post Icons
You may choose an icon for your message from the following list:

Register Now

In order to be able to post messages on the Kawasaki ZX-10R.net forums, you must first register.
Please enter your desired user name, your email address and other required details in the form below.

User Name:
Please enter a password for your user account. Note that passwords are case-sensitive.


Confirm Password:
Email Address
Please enter a valid email address for yourself.

Email Address:


  Additional Options
Miscellaneous Options

  Topic Review (Newest First)
05-29-2019 12:38 AM
palomartian I went with some 5/8" delrin rod and made a three point mount using the stock RR, fuse holder, etc bracket in the stock location. Measured the stand-offs on the stock plastic, cut some spacers, and ground the ends to match the body contour. Attached the spacers to the bracket with the stock screws. Drilled through the body and into the spacers, then ran in some screws. One I through-bolted as it was a bit short for screws coming in from both ends. Worked about as well as could be expected. Ended up a little higher than stock so I could secure it to the race body on relatively flat areas. Might even work.
05-28-2019 06:56 AM
ddipaola Reactive Parts makes a bracket that mounts to the frame and gets the rectifier out of the way...
The bracket might not fit perfectly but after some practice (and heat cycling from the engine) it should get much easier to take on/off (but you can leave it on full time).
05-23-2019 08:28 PM
palomartian I did search (eventually, lol). I like your idea. I'd like to try the kit wiring harness/puke tank/RR mount at some point. What I don't know is if all the stuff I turned off with the Woolich box will make that harness work with the stock ECU.
05-23-2019 07:36 PM
Cable The KRT oil catch can has 2 posts for the regulator to mount to. You'd need to either extend some wires, or use the race harness, but it makes for a good location.

Do a search, there's a couple of threads on the topic.
05-22-2019 10:27 PM
Regulator mounting

Looking for ideas on mounting the regulator/rectifier with race bodywork on my 2018.

so far I'm planning to build standoffs with some delrin rod and screw it to the fairing in the stock location.

Posting Rules  
You may post new threads
You may post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

For the best viewing experience please update your browser to Google Chrome