gen 3 power commander v setup questions re water temp sensor
trying to help a friend setup a power commander v on gen 3 bike with auto tune. Trying to get the temperature set so it will not auto tune untill warm and the power commander wants a voltage for a given temp. The manual shows 2.8-2.97 v at 20 degrees c or 68F but the power commander window starts at a higher temp and it is not a linear functionm so I cannot just calculate it. Anybody done this and if so what temp values vs voltage are you using. To me it seems really dumb to have auto tune change values based strictly on time when the bike is not up to running temp.
Last edited by flash515; 05-01-2011 at 02:03 PM.