Kawasaki ZX-10R Forum banner

my 04 on the dyno

1K views 14 replies 9 participants last post by  kiwifruit 
#1 ·
Just had a call from the shop doing my custom map.....
169bhp
im happy with that! :-o

mods:
PC3, Ivan's TRE, Racefit growler, K&N


will post up the sheet when i get my hands on it

thought id share that with you, was more than i was hoping for :thumbsup:
 
#6 ·
...........................in a wind tunnel with air being stuffed down it's throat at 180 mph................................LOL! Hey I am not saying it's not true just that higher readings could be lower on difeerent dynos and lower readings could be higher. I would be happy with 186! :wink:
 
#7 · (Edited)

Attachments

#12 ·
blackisfaster said:
My new 06 10R stock did 145. Started a post on this. DYNO must have been low, becuase a 06 ggsxr1000 with full pipe did only 148

The same shop last friday did a custom map on an 06 with a full muzzy system/PC3. That pulled 173bhp. When i heard that i thought "i will get about 155-160"..... was stoked to get so close in comparison!

It does seem like the machine is reading higher rather than lower (suits me lol)
 
#14 ·
Very close to my numbers. I need a custom map.


kiwifruit said:
Just had a call from the shop doing my custom map.....
169bhp
im happy with that! :-o

mods:
PC3, Ivan's TRE, Racefit growler, K&N


will post up the sheet when i get my hands on it

thought id share that with you, was more than i was hoping for :thumbsup:
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top