As the title say's, How to build your own "Exhaust Servo Eliminator"
For "ONLY" The Gen 1, 2, & 3 ZX10R's.
I also build one's for the Gen 4 and ZX6R's too
but you will have to PM me or email me at [email protected]
THIS MOD DOES NOT WORK ON ZX6R's OR GEN 4 ZX10R's OR Z1000's
Also, If you cannot build them, PM or email me and I can do it for you.
1. I made up the capacitor / resistor circuit (Pictured Below)
Make sure the direction on the capacitor is correct / The arrows << on the Capacitor face the Black wire.
The resistors do not matter as far as the direction, they work either way.
Once you are sure about your circuit, solder it all together.
Then, mix up the epoxy in approx 1" W x 2" L x 1/2" D plastic tray,
it comes as part of the packaging of the epoxy.
Then submerse the Exhaust Servo Eliminator
in the epoxy to where the top is covered.
This is for durability and insulation.
Once it has hardened and dried. Use a grinder or buffer to smooth
out any sharp edges or rough spots.
Next, wrap in electrical tape and plug it in.
I have installed this on my bike and
NO FI light after removing the servo motor.
I rode the bike for about an hour & 1/2 in all gears and throttle positions.
1 last thing to add.
If you don't want it to bounce around in the bike, get some sticky backed velcro and attach it to the subtray.
Also, I gotta give PROPS to Racejunkie05
for showing me the circuit.
If you cannot do it, PM me and I can make arrangements for me to do it for you.
Also I have edited this page so you do not have to read a bazillion pages.
All info is in this first post now.
Hope this helps my bro's here. This place is almost my second family. lol
Here is a way to make room in the back part of the sub tray for more items.
Once you remove the servo motor, your PCIII can go there and have all kinds of room in the back.