Kawasaki ZX-10R Forum banner

Exhuat servo?

949 views 14 replies 4 participants last post by  9520G 
#1 ·
I just installed a full system and took off the exhuast servo but left the wire intact, just took them off the closing/opening mechanism. I didnt drive the bike around but I did turn on the bike. I thought that throws on the Fi light. Was I wrong or did I just get lucky or do I actually have to ride the bike a cuople of miles for the error code to kick in?
 
#2 ·
If you left the servo motor plugged up and just unhooked the cables then you won't get an error code.

Tread
 
#4 ·
The servo eliminator will allow you to take out the servo motor and free up the space and weight without getting an error code.

Tread
 
#14 ·
I removed ny servo motor and Yes I have the error code or FI light on but I don't care seeing I never look at it. Also I thought it doesn't affect the bike at all ? Its just an red light right?
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top