lOCKHART sLIDERS ON 08 ZX10

[zx10rwannabe]

Hey got thse lockhard phllips frame sliders for my 08, and was wondering how ppl cut there left side cover to install the slider? pictures woudl be soo awesome...

THanx in adance

[zx10rwannabe]

also is there a way to make those running two runnig headlights into integrated blinkers? what woould happen if you just plugged them in where the blinkers get plugged into?

[zx10rwannabe]

bump

[925stunna]

Not sure on the sliders, but i popped off my blinkers and spliced into my running lights and threw in some amber bulbs. Looks much better IMO, though my white LED's would look nice next to my HID's but stil want blinkers. i say, DO IT!

[TENN10]

Cutting the left side cover is not easy. The angle is really steep.

I used a tip that I seen somewhere on this forum to locate the mounting hole with a laser. Using putty on the inside of the plastic works well also.

Mark the center of the hole then drill a pilot hole. I used a hole saw to then cut the diameter. You just really have to pay attention to the angle that you are drilling. The hole will be oval (not round).

Its not a very difficult task, but I have definately cut easier frame slider holes.

[zx10rwannabe]

its wierd it doesnt seem like the bolt on the frame slider on the left side will e ven fit there, the bolt that goes there is an 8mm, this bolt that comes with the slider is huge... and btw im talking about the hole that goes through the coolant jug...ill take pics and post up...

[adchan]

you should have a replacement bolt that is longer.

I used the laser method and ended up larger than I needed, cleaned it up with some auto trim. Just go slow and make sure you angle is right.