Did I see a post where you are using a micro squirt? Can you tell me if allows you to tune fuel and timing of the motor? Are you using it as a stand alone ECU? How is it working out??
Hey, I've been working with Dustin (Spazzonazx) and hes been helping me getting a microsquirt up and running. His ignition settings for a Gen 2 don't seem to be working for my Gen 1. Any chance you could help me out with some of the basic ign settings?
Hi, do you have any idea how to eliminate the false reading of low. Fuel on the zx10 06, I juet installed an AEM 380 fuel pump externally and the low fuel ligjt turns on.
Thunder did you have something for putting the shaft with the gear inside the crankcase ?
The shifting fork surely have an order to reassembly ?
When looking to your video I remark I do some erros in reassamble the shaft with the gears.
The snap ring have a dot on one of the side.....doesn't know that and probalby misplaced it.
The toothed washer have a way to put on the shaft ?
The two forks on the transmission have a little pin not aligned in the middle of it so there's probably a way to put on the fork shaft ? any idea ??
Now I looked at your video I understand I probaly misplaced the toothed washer and snap ring, afraid of doing something wrong about the fork. Eevery thing seem to fit together in the crankcase but afraid now.
Red, I can make my own but don't want to do the work. I use a resistor to tell the ecu it is in 5th gear all the time and I have a flashed ecu so I could use the gear the stock indicator and put the stock wiring back. The engine is in the car pictured below.
i have a zx-10r 2007 im tired for the second time clutch basket failure. the first time one of the three rivets failed and then caused the whole basket failure. i got a new oem basket from ebay and installed. the second time i have used the same clutch disks but i changed the first two broken i have put used clean ones. now i have the second disk broken a small piece of it and the clutch basket with three cracks on the top at the ring. i do lots of wheelies but i am smooth slipping the clutch after the first failure sometimes im agressive. now im waiting for a used basket clutch from ebay to install it.
can you please tell me the reason for the failure of the disk and basket?