Swingarm install help
I'm trying to reinstall my swingarm (05 zx10r) and I'm having a problem with getting pivot shaft properly tightened. I'm following the manual instructions as follows:
1. Install the swingarm and insert the pivot shaft. Tighten the pivot adjusting collar to 14 ft-lb.
2. Tighten pivot adjusting collar locknut to 72 ft-lb.
At this point, the swingarm is moving freely up & down.
3. Then I tighten the pivot shaft nut to 81 ft-lb.
Now the swingarm is extremely tight and takes a lot of effort to move up and down. I've taken it apart and put it back together 3 times now. What am I missing? Thanks in advance.
2005 Magma Red ZX10R, Brock’s shortmeg full-system, Dynojet pc3 with Brock’s map, Hellsrazor Servo Eliminator, Block-offs, Cometic thin head gasket (.45mm), Engine Ice Coolant, Gen-3 race cam, Dano’s TRE, BMC race filter, Factory Pro velocity stacks, Cycle Concepts Drag Pak clutch kit, Gold shorty levers, LSL handlebar kit, Drive Systems X2 Ultra-Lightweight 520 sprockets (-1, +2), EK ZZZ 520 Gold chain, Dunlop Q3s, RB Batteries lithium battery (1.4lbs), 1/4 turn keyless gas cap