Anyone going to get the euro version flushmount blinkers? They look alot better than the US slugs we get. If so, where and how? :?:

i took BD's advice and ordered the fronts and backs from zpower (uk)...i called them, and the guy was very helpful and knew what i was looking for...i think it was about $160 for fronts, backs, and shipping from uk.

Ordered them last week through my family in UK.

i took BD's advice and ordered the fronts and backs from zpower (uk)...i called them, and the guy was very helpful and knew what i was looking for...i think it was about $160 for fronts, backs, and shipping from uk. Thanks, Wouldnt happen to have a web address, part #'s, or phone # would you?? Any help is greatly appreciated! Geezer, you know of an easy way for fellow zx10 riders in the US to come across these items?? Thanks Geez.

I am not affiliated with this website at all but am just passing on the information: Part Numbers (front signals only): left is 230400021 , right is 230400022 zpowerdave@yahoo.co.uk http://www.z-power.co.uk/

I am not affiliated with this website at all but am just passing on the information: Part Numbers (front signals only): left is 230400021 , right is 230400022 zpowerdave@yahoo.co.uk http://www.z-power.co.uk/ well there you go........... i did that without moving my lips:wink: :mrgreen:

part numbers rear: 23040-0023 left 23040-0024 right

Has anyone confirmed that the mounting / install of the Euro rear signals are in fact exactly the same as the US :?: :?: BD

Has anyone confirmed that the mounting / install of the Euro rear signals are in fact exactly the same as the US :?: :?: BD Hey BD,I talked to the jentelman that is importing the euro blinkers on the other thread. He is suppposivly going to have a large quanity of sets front and rear. He told me that they bolt right in but for the front you need 3 screws per side and one rubber grommet per side to make it a factory install. When you ordered your blinkers from the uk,did the guy who sold them tyo you sell you the grommets and screws?

Has anyone confirmed that the mounting / install of the Euro rear signals are in fact exactly the same as the US :?: :?: BD Hey BD,I talked to the jentelman that is importing the euro blinkers on the other thread. He is suppposivly going to have a large quanity of sets front and rear. He told me that they bolt right in but for the front you need 3 screws per side and one rubber grommet per side to make it a factory install. When you ordered your blinkers from the uk, did the guy who sold them to you sell you the grommets and screws? I don't know, nor did i ask..but i shall be inquiring tomorrow. BD